Volkswagen ID.7: Switching the turn signals on and off

Fig. 1 On the left-hand side of the steering column: lever for turn signal, high beam and windshield wiper.

1. Right turn signal .
2. Left turn signal .

Switching the turn signals on and off

1. Switch the ignition on.
2. Move the lever out of the center position into the desired position→ fig. 1 .
3. To cancel the turn signal, move the lever back to its basic position.

If no chime sounds when the turn signal is on, contact suitably qualified professionals and have the vehicle checked.

Volkswagen recommends contacting an authorized Volkswagen dealer or authorized Volkswagen Service Facility.

3-blink turn signal

1. Move the lever upward or downward to the pressure point and then release the lever.

The turn signal will blink three times.

To stop the 3-blink turn signal before it ends, move the lever immediately to the pressure point in the opposite direction and release.

The 3-blink turn signal can be activated and deactivated in the vehicle settings in the Infotainment system (→ Vehicle settings menu) .

WARNING

Using the turn signals incorrectly, not using the turn signals, or forgetting to turn the turn signal off can mislead other road users. This can cause accidents and serious or fatal injuries.

• Always activate the turn signals correctly when changing lanes, passing, or turning.
• Switch the turn signal off again every time you finish changing lanes, passing, or turning.

The emergency flashers also work when the ignition is switched off

Some settings can be saved in the driver personalization user profiles and will change when the user profile is switched.

Adjusting the head restraintsSwitching the lights on and off